Archive for the ‘Error Codes on LCD’ Category

My Epson printer is stuck in Recovery Mode. How to solve?

You have attempted to update your Epson printer using the Epson Driver Update and Download Navigator software but have found that the printer is stuck in Recovery Mode. This message is displayed on the product’s LCD screen and you will be unable to perform any actions until this issue is resolved. This error can occur […]

LCD codes Status messages

If you see an error code on the LCD, see the solutions here to troubleshoot it. Can be used for all printers with LCD monitor TX-series, PX-series, XP-series, L-series etc. LCD code Condition / Solution E-01 A fatal printer error has occurred. Turn the product off and then back on again. If the error continues, […]

Error 0x9A on Epson XP series printers

Error 0x9A means – “Circuit error (include blowout of a fuse). Main board failure” Printhead electrics have been flooded with ink causing this error. The ink get to electric cirquit on printhead and electrical jacks. Solution: Unistall printhead and clean all electrical jacks and dry them very good for about 2 days. Then install it […]

E-01 Error Code on Epson printer LCD – tips to fix

If you see an error code on the LCD, see the solution here to fix it. E-01 Error Code – A fatal error has occurred. This error is determined in the Epson Service Manual as FATAL ERROR. It means the printer can’t finish his selftest. When you turn the power ON the printer begin to […]