My Epson printer is stuck in Recovery Mode. How to solve?

You have attempted to update your Epson printer using the Epson Driver Update and Download Navigator software but have found that the printer is stuck in Recovery Mode.

This message is displayed on the product’s LCD screen and you will be unable to perform any actions until this issue is resolved.

This error can occur if the firmware update procedure is interrupted, e.g. accidental powering off the product, cables being removed or the installation being cancelled.

Solution:

Wait for a few moments and a pop-up should appear on the computer screen, clicking on the link indicated below will direct you to a tool that will correct this issue.

Epson_Recovery_mode

Once the download is complete, run the file as normal for your operating system and follow the on-screen instructions to complete the firmware update.

In the event that the pop-up mentioned above does not automatically appear or has been accidentally cancelled, the Firmware Recovery Tool can be accessed manually from the Epson website, refer to the following article for more infomation: How to download drivers and software from the Epson website

Once the download is complete, run the file as normal for your operating system and follow the on-screen instructions to complete the firmware update.

Supported Models: P-series, SX-series, TX-series, PX-series, WF-series, WP-series, XP-series, L-series

You can leave a response, or trackback from your own site.

Leave a Reply

You must be logged in to post a comment.